standard for factory-coated bolted steel tanks for water storage

standard for factory-coated bolted steel tanks for water storage introduce

standard for factory-coated bolted steel tanks for water storage is different in every country.

Conventional protection measures shall be taken for standard for factory-coated bolted steel tanks for water storage during the process of starting or lifting to the destination.

The relevant lifting operation regulations must be observed, and the pull rope shall be tied at the proper position of the standard for factory-coated bolted steel tanks for water storage to avoid the uncontrolled swing of the tank. In order to lift stably, the tank body must not fall off during lifting, and strictly prevent falling or collision with other objects.

The damage caused by this may lead to cracks in the internal corrosion-resistant layer, leakage, structural layer damage and strength reduction.

enamel assembled tank

Since its establishment, our company adheres to the concept of quality for survival and reputation for development. We are aggressive and brave in development.

We have established a set of strict quality control system to ensure that the standard for factory-coated bolted steel tanks for water storage are checked from the raw materials into the warehouse to the products leaving the factory.

We are strict in testing to ensure the quality of the products and strive to provide customers with high-quality and satisfactory standard for factory-coated bolted steel tanks for water storage.

bolted tank design code

standard for factory-coated bolted steel tanks for water storage description

Environmental problems that should be paid attention to in the process of standard for factory-coated bolted steel tanks for water storage construction. ① Enclosure protection. Generally, the anti-corrosion work of the storage tank is basically carried out in the open air

so the windblown sand will be relatively large, so the enclosure should be set around, and the position of the coating operation should be set at the upper air outlet, the lower air outlet, and the sand blasting operation, so as to reduce the impact of the windblown sand.

The time of coating area and sand blasting operation shall be staggered to avoid the sand blasting operation affecting the quality of painting. ② Ventilation is required for operation in the tank. During the construction operation in the standard for factory-coated bolted steel tanks for water storage, ventilation shall be maintained.

porcelain enamel glass lined tank

If the ventilation is poor, forced ventilation measures shall be taken. ③ Temperature control. The surface temperature of standard for factory-coated bolted steel tanks for water storage shall be 3 ℃ higher than the site temperature during painting operation, and the site temperature shall not be higher than 50 ℃.

biogas assembled tank

If the surface temperature is too high, there will be air bubbles in the paint film, which will reduce the adhesion. If the temperature is too low, the conventional paint film is easy to freeze and not easy to cure. ④ Humidity impact. Construction shall not be carried out when the air humidity is greater than 85% or when the weather is rainy, snowy or foggy.